The stainless steel AS-i Safety Monitor controls the outputs of the AS-i Safety Output module by using a safe AS-i single address. To set the safe AS-i address, the dip-switch has to be in the `Prg' position. Addressing can then be accomplished by using an AS-i addressing device, for example. Several AS-i Safety Output modules can have the same safe address and can be controlled via this same safe address on a AS-i circuit. All AS-i Safety Output modules with the same safe address are controlled simultaneously.
In addition to the safe single address the module also supports an AB-address used to transmit the states of the standard inputs or of the electronic device monitoring (EDM).
To set the AB address, e. g. with an AS-i addressing device, the dip-switch has to be in the `Run' position. Another AB slave is available for the diagnostic. The bit values are shown in the diagnostic table.
Special Features:
-AS-i Safety Output Module with standard 4I/2O
-Safe electronical output
-Additional 4 standard inputs, 2 outputs
-1 input for electronic device monotoring (EDM)
-SIL 3
-Protection category IP20
Login
Search
Print
